Introduction

Documentation Status Discord Build Status Code Style: Black

I2C and SPI driver for the Bosch BME280 Temperature, Humidity, and Barometric Pressure sensor

Installation and Dependencies

This driver depends on:

Please ensure that the driver and all dependencies are available on the CircuitPython filesystem. This can be most easily achieved by downloading and installing the latest Adafruit library and driver bundle on your device.

Installing from PyPI

On supported GNU/Linux systems like the Raspberry Pi, you can install the driver locally from PyPI. To install for current user:

pip3 install adafruit-circuitpython-bme280

To install system-wide (this may be required in some cases):

sudo pip3 install adafruit-circuitpython-bme280

To install in a virtual environment in your current project:

mkdir project-name && cd project-name
python3 -m venv .env
source .env/bin/activate
pip3 install adafruit-circuitpython-bme280

Installing to a connected CircuitPython Device

Some devices, eg. the QT-PY, are very limited in memory. The BME280 library contains two variants - basic and advanced - which give different levels of functionality.

Installing the BME280 library could have the following outcomes:

  • It installs successfully and your code runs successfully. Woo-hoo! Continue with your amazing project.

  • It installs successfully and your code fails to run with a memory allocation error. Try one of the following:

    • If your code.py is large, especially if it has lots of comments, you can shrink it into a .mpy file instead. See the Adafruit Learn Guide on shrinking your code.
    • Only use the basic BME280 implementation, and remove the following file: <CIRCUITPY>/lib/adafruit_bme280/advanced.mpy where <CIRCUITPY> is the mounted location of your device. Make sure that your code only uses the basic implementation.

Usage Example

import board
import time
from adafruit_bme280 import basic as adafruit_bme280

# Create sensor object, using the board's default I2C bus.
i2c = board.I2C()   # uses board.SCL and board.SDA
bme280 = adafruit_bme280.Adafruit_BME280_I2C(i2c)

# change this to match the location's pressure (hPa) at sea level
bme280.sea_level_pressure = 1013.25

while True:
    print("\nTemperature: %0.1f C" % bme280.temperature)
    print("Humidity: %0.1f %%" % bme280.relative_humidity)
    print("Pressure: %0.1f hPa" % bme280.pressure)
    print("Altitude = %0.2f meters" % bme280.altitude)
    time.sleep(2)

Contributing

Contributions are welcome! Please read our Code of Conduct before contributing to help this project stay welcoming.

Documentation

For information on building library documentation, please check out this guide.

Indices and tables